![]() Press Esc or the Close button to finish the command.Press S to switch Draft snapping on or off.Note that edge selection is not possible for subsequent dimensions. All subsequent dimensions will start from the final point of the previous dimension, and will use the same baseline as the first dimension. If continue mode is on, the command will restart after finishing, allowing you to continue creating dimensions. This mode only works for linear dimensions. Press T or click the Continue checkbox to toggle continue mode.If global mode is on, coordinates are relative to the global coordinate system, else they are relative to the working plane coordinate system. Press G or click the Global checkbox to toggle global mode.If relative mode is on, coordinates are relative to the last point, if available, else they are relative to the coordinate system origin. ![]() Press R or click the Relative checkbox to toggle relative mode.It is advisable to move the pointer out of the 3D view before entering coordinates. Or you can press the Enter point button when you have the desired values. To manually enter coordinates enter the X, Y and Z component, and press Enter after each.The shortcuts mentioned here are the default shortcuts. The single character keyboard shortcuts available in the task panel can be changed. The displayed angle depends on the edges and the picked point.To position the dimension arc pick a point in the 3D view.Hold down the Alt key, select two straight edges in the 3D view and release the Alt key.Repeat this to select a second straight edge. Press E or the Select edge button and select a first straight edge in the 3D view.Hold down the Shift key and pick a point in the 3D view.Hold down the Alt key, select a circular edge in the 3D view and release the Alt key.Press E or the Select edge button and select a circular edge in the 3D view.Optionally select a circular edge in the 3D view.Move the pointer to the left or right of the edge or points.Hold down the Shift key, move the pointer and pick a point in the 3D view.Move the pointer above or below the edge or points.Pick a point in the 3D view, or type coordinates and press the Enter point button.To position the dimension line do one of the following:.Pick a second point in the 3D view, or type coordinates and press the Enter point button.Pick a first point in the 3D view, or type coordinates and press the Enter point button.Define the measured distance by picking points:.Hold down the Alt key, select a straight edge in the 3D view and release the Alt key. ![]()
0 Comments
Leave a Reply. |